Recent content by Alan0354

You can do it on some, but most won't work. One think about using washers is to use larger diameter washers to spread the stress in the pivot area to bigger area. A lot of knives don't have the room when they design for ball bearings. I did it on a few with good result, but no guaranty.

I am not trying to be fancy, it's only a tool and it's cheap knife. I screwed it up, so I just want to buy the OEM scales. Hell the whole knife is only $42.

I contacted all of them already.

Nobody has information? How can Steel Will selling knives and no way to buy parts? Alan

Ball bearings is a lot thicker than washers. To avoid making the knife thicker, they have to thin out either the black at the joint or the frame to accommodate the bearing. That creates a weak point. I bought quite a few knives with ball bearings, they really cut into the blade at the joint and...

I want to check anyone know where can I buy the ‎Fiberglass Reinforced Nylon Handle(scales) for the Steel Will Cutjactk 3.5" knife model # SMGC221? I just cannot find the contact info of Steel Will. Their web site doesn't have direct contact info. I wrote to a lot of knife stores with no luck...

Hi The only brand that I know that has knives with no ball bearings and have the index finger tap to deploy the blade is Steel Will. The index finger tap I refer to is shown in the picture...