Recent content by BladeFabricator

  1. BladeFabricator

    Hello from western NC

    Welcome to the Knife Dogs Forum :60:
  2. BladeFabricator

    Hello from Central Florida

    Welcome to the Knife Dogs Forum :60:
  3. BladeFabricator

    re-introduction....been off here for a couple years.

    Welcome to the Knife Dogs Forum :60:
  4. BladeFabricator

    Hello from NJ

    Welcome to the Knife Dogs Forum :60:
  5. BladeFabricator

    Hello from the Atlanta suburbs.....

    Welcome to the Knife Dogs Forum :60:
  6. BladeFabricator

    Hey Fellow Knife Buds!

    Welcome to the Knife Dogs Forum :60:
  7. BladeFabricator

    New to the knife making world

    Welcome to the Knife Dogs Forum
  8. BladeFabricator

    Hi guys

    Welcome to the Knife Dogs Forum :60:
  9. BladeFabricator

    Maker from the uk saying Hi

    Welcome to the Knife Dog Forum :60:. I am a knife maker from Greece. Nice works by the way ;)
  10. BladeFabricator

    new born baby pup knife maker

    Welcome to the Knife Dog Forum :60:
  11. BladeFabricator

    Hello everyone.

    Welcome to the Knife Dog Forum :60:
  12. BladeFabricator

    Hello logged in again

    Welcome back to the Knife Dog Forum :60:
  13. BladeFabricator

    just joined up again

    Welcome back to the Knife Dog Forum :60:
  14. BladeFabricator

    Hello everyone. I am logged back on after a hiatus of 2 or 3 years.

    Welcome back to the Knife Dog Forum :60:
  15. BladeFabricator

    A short tanto sword from Elmax steel.

    That's true, Elmax can become as hard as 61 HRC but I took this piece to 57-58 lest it should break, cause it is pretty long for a knife.
Back
Top