Recent content by cardoso5fr

Most of the bearing are that sort of thing now :D

Thank you :D

I've started that balisong more or less 1 year ago.... But i was lazy in 2018 :) 14C28N flat grind, TA6V4 for everything except blade, bearing and screw , CC bearing . Latchless.

Not my sort of knife, but to think it's all hand made, it's always a pleasure to see :)

Thank you very much :). Years ago, i didn't understand why people enjoyed friction folder and kiridashi, and finaly i did some and use them. And with the time, that is almost the two sort of knife i have with myself :D (except balisong to play sometime)

Thank you very much guys :). The clip function well especially if you use it as a pen clip on a tuxedo or something like that :D

Un cardoff 90MCV8 and T40 anodised and beadblasted. Ta6v4 spacer,Bronze Phosphore washer 8 cm sharp, .

It's marvelous. I'm ultra fan of the result. Amazing work and blade.

Thank you :D

It's a 34 pieces balisong puzzle. 14C28N with 4" sharp, 3 mm TA6V4 handle branche . Ta6V4 latch and tang pins. Friction latch. Everything is set up on bearing. Double hollow grind but it's a thin false edge on the back.

Thank you very much. Build off is contest . Each knifemaker make a knife on the theme and post a wip :).

JD Halloween Devil Fighter 90MCV8 5mm , 17 cm hollow grind, double edge :). 29 cm long Ta6v4 bolster and pins. Kirinite and carbon fiber :D

Thank you very much to have put my knife as proposal :). It's really nice to you :D

A big balisong, 15N20 4.5' if my memory is not too bad, titanium grade 2 liner, ball bearing, Ti grade 5 latch en tang pins. Friction latch. Ghost jade G10 scale.

A friend from another forum is dead that year and for his memory commemoration the CZEN challenge has for theme the PUUKO a sort of knife he enjoyed especially. I did that one with O2 tool steel 4mm thick, 10 cm sharp (more or less), beadblasted. brass and oak for the handle. A small...