Recent content by JDSanders635

Another one off the bench and headed out the door. 80CrV2 steel with G10 handles.

I just finished this liner lock and it is now available for purchase. 1095 steel blade with epoxy and g10 handles. Everything except the screws were forged/fabricated in my shop from start to finish. $295 shipped to you.

I just finished this liner lock and it is now available for purchase. 1095 steel blade with epoxy and g10 handles. Everything except the screws were forged/fabricated in my shop from start to finish. $295 shipped to you. Edit: after posting I realized I posted in the wrong thread. I apologize.

Just finished up this liner lock folder. 1095 steel with epoxy and G10. Everything except the screws were forged/fabricated in my shop.

Just finished this one up tonight. My son was helping a friend clean out an old barn and they found this piece of farriers rasp that someone at some point had cut out to make a knife. I figured I’d finish the job somebody else never did. It’s kind of cool to think how long it has been in there...

Yes sir daggers and karambits are very difficult to get right on. I think I lose a couple months off my life every time I make one

Since I don’t have a lathe I used my drill press. I improvised a jig with a 6”x3/16” bolt and a couple of nuts and washers to hold the piece in place. One day I will get a lathe but adapt and overcome until then.

This is a Fairbairn Sykes inspired dagger that I did recently. It is 80CrV2 steel that has been gun blued. The handle is white oak. The cross guard and pommel are both mild steel. Everything was forged and fabricated in my shop.

Thank you all for having me. Here are a few of the pieces I have done in the last few months.

Hello sir. My name is Jake and I am a knife maker. I would be happy to talk to you about what you are looking for. I have an Instagram page (if you are on social media) to look at some of my work. It is Gilametalworksknifecompany. If you look through my work and think I might be a good fit let...

My name is Jake Sanders. I am a knife maker based out of Deming, NM. My company is Gila Metal Works Knife Company. I am always willing to learn from other makers and grow as a Bladesmith. Thanks for having me.