Hello again
Just wanted to say how much I appreciate the advice from all who took the time to reply to my question on heat treating 1095. I will try the suggestions with my oven and quench medium. Also I tried grinding off all the death and did find hard steel. Thanks all for letting me benefit...
Hey all.
I'm sure that this subject is both asked about and, discussed a lot here. I usually work with 5160 and D2 tool steel. Lately I have tried working with 1095 and it hasn't gone well. I am using an older Paragon K.M.-14D heat treating oven and went with the recommended 1450 degrees to...
Hi all.
I just signed up n am learning my way around the forum. I am from York Nebraska and have been making knives for a few years now. I look forward to sharing information and ideas with everyone. This is a project that I finished recently