Search results

Thanks fellows, Keep looking Scott they are out there. This is the search engine I use for Craigslist/Ebay/Amazon and it works great. http://www.searchtempest.com/

Look's Great, very nice work !!

Nice work looks good

Here it is painted, with High Heat semi- gloss and reassembled. Best of all the wires get hot!! So far, I've got about $150 in it with the paint and the stainless steel sheet metal screws, I bought to replace all the old screws with. It will probably be a awhile before I can afford to...

I got my CPM154CM from Aldo and I believe it is.156".

Prepped for paint

Thanks for the feedback. I think I'll spend the extra money for ramping

I really don't know if I need the ramp function as I don't have any experience heat treating. For those of you that heat treat do you use the ramp function? If so what are the advantages of ramping?

Thanks for the advise everyone. I'll will keep the oven at it's rated temp. I didn't think about the possible insurance liability. I definitely want to upgrade it though to a PID control. The existing control is a voltage control only and there is no T/C. Tim - I checked out the controller at...

I picked up this older Paragon E14A on Craiglist for $100 from a nice fellow that use to make knives. I haven't hooked it up yet to test it, but he told me that the last time he used it several years ago that it worked and that the heating elements had been replaced not long before he stopped...

Happy Birthday Bruce

Look's good Ken, Keep up the good work. I have a Lanny's Clip I started about a month ago on my bench and have not had a chance to get back to yet. Hopefully I'll be able to spend some time on it this weekend. Jim

Nice Work, they both turned out really good.

Look's nice and I'm sure there's a market for it, but I personally prefer the more traditional slipjoints

Thanks Ausbrooks

Nice work, Looks like you've been busy since the show. Jim

I started with the 20lb and went to the 40lb. Which has worked well for me. Mine is mounted rod down. Below are the parts I ordered from Mcmaster Carr when I first put it together. 20lb Spring gas piston McMaster Carr 9416K111 Bracket for gas piston McMaster Carr 9416K29 Eyelet for gas piston...

Does anyone know of any other suppliers of 3/32 ID x 3/16 OD folder bushings, other than K&G Supply? Jim

Looking Good, Calvin

Chill8433 -That is correct. I have my 2" wheel setup to shrink the belt angle and my 1" setup to grind. They can be swapped back and forth. Surprisingly it does not eat up the wheels, most likely because the wheels are spinning at the same rate as the belt.