Search results

Does the account cost $$$? I lost all my photos once before. It's a shame we can't send a photo on a PM. I tried that to one of the guys about a hydraulic press.

Not to long ago this would have been my thread. More then a few people here have asked the same questions. I'll go with the top right.

Last name under it would work well.

As long as you like it!!!

I've never looked for 1x40 belts before. Kingsport is a very good abrasive. If you looked around I bet you could find it in a bulk roll and save some money over belts.

I wish you lived next door! That is some of the finest work I have seen. You did a wonderful job!!!

I watched one show last night. They had a guy on with "1" year experience as a part time smith. By the end of the first round he turned in a section of a coil spring. Nothing worked for him. That was to bad.

Lyne is a very lucky lady. Good for you!!

At work at 5am. Good for you. Me too. I hate getting up at 3:45am. Do you work out of the house. (garage/shop) Your knife as usual will look great!!

I'll be looking forward to seeing it complete. Hurry up! :)

That's just my bad luck. Looks like it would of been a great time. I did not check the weather again until later the next morning. Sounds like it missed you. I'll be looking forward to the next one. Make it 85° and sunny please! :cool:

lol,,,,,, 90% chance of rain & snow! Can ya pick a day I can ride down. :) If the weather is not to bad it sounds like fun.

lol,,,,,,, Your right arm press did a fantastic job!!

Fred you did a fine job. I love the file work. Did you make the damascus with your new press?

Is it a dusty material?

Looks good Op. Why don't you give some 1095 a shot if you are looking for a hamon? I can say you are doing better then me. I have made one dagger about 5 years ago. Because I do this stuff for a living it was simple to trig it out and cut a 2X4 to the right angle. Freehand is way good. You have...

Rey, look at your thread. You will see the word "Report" at the bottom right side. Click on that. It will say Edit & Delete. Good luck. LOl,,,, left side!!

^ Yep ^

Ah,,, ha,, ha, ha!!!!

15n20 to the best of my knowledge is not air hardening steel. More like 1084.