Search results

I have a B111 and want to build a flipping plate. Does anyone have one they have made that can post a picture. I know They can be bought I just want to make my own and need a little nudge in the right direction.

I have ordered a PID controller to get me a temp reading on my Sandia forge. Can I drill a hole into the forge body or just stick the probe straight into the door of the forge?

I have the billet drawn out on it's side to 68 layers. My first question is how many layers gives the best look. My second question is when I get the layer count to where I want it then what? I think I am to cut the handle off and weld it on the side of the billet. fut down the center of the...

OK here goes. When making a can of stainless Damascus. What stainless steals do you put in the can and what stainless powder do you fill the voids with?

http://www.cnccookbook.com/CCKnifeMakingGrinders.htm

This might not work but my plan is to make my B111 operate like the TW-90 where I can use it vertical or horizontal. I saw a GIB done like this. If anyone has any ideas lets here them. When I start this I will take pictures.

I will start by listing what I have first. I have a B111 belt sander, a 3-1 mill, drill, lathe, a welder, a heat treat oven and a few hand tools. With a budget of $1200 What would you get next?

I just purchased my first belt sander. It is a B111 it has reverse. What would be the use for reverse?

I have a very large supply of cable. I would like some advice on heat treating. The cable I have is from the drilling line on a rig. I don't know what steels are used in it. Any help would be awesome.

I was very lucky today. I was able to get a 3-1 lathe mill-drill press, And a 25lb Little Giant. The hammer needs to be rebuilt. I have a 50lb and a press being built now. I was wondering if I should sell the hammer after I rebuild it or keep it for my shop?