Base for the press

opaul

Well-Known Member
Looks good. I like the mobility and a couple of places to put a ball peen hammer.
 

BossDog

KnifeDogs.com & USAknifemaker.com Owner
Staff member
Nice build so far. What are going to do about dies and how you change them out?
 

Freds Edge

Well-Known Member
I am working on the dies, I have several ideas but have not settled on one yet . I rember Ed making some comments on dies , I will go back and read that again
 

springer82

Well-Known Member
Fred,,,,
Would you be kind enough to take a few pictures for me. I would love to see how the upper section where the top die goes slides up and down. How thick is the top of the base table. How thick and tall is the I-beam. That's going to turn out to be a very nice press. I need to know stuff!!! lol,,,
 
Top