v-6 Well-Known Member Mar 20, 2011 #1 I milled a bloodline in a new blade and was wondering how to get the little lines out of the bloodline, that the bit put in it. the bloodline is a 1/4 " wide and about 3/16 deep. any help would be nice. thanks vern
I milled a bloodline in a new blade and was wondering how to get the little lines out of the bloodline, that the bit put in it. the bloodline is a 1/4 " wide and about 3/16 deep. any help would be nice. thanks vern
murphda2 Super Moderator and KD Blade Show Boss Mar 20, 2011 #2 Small piece of dowel rod Wrapped in sand paper with alot of elbow grease wil probably get it for you.
Small piece of dowel rod Wrapped in sand paper with alot of elbow grease wil probably get it for you.
