OK, here's the press setup on the cart. That cart works MUCH better than I was expecting when I opened the box. It's rated at 1,000 lb but I don't see how. The posts are 1" diameter, while a similar cart I purchased from Sam's has 1-1/2" posts, and the wire of the shelfs are all the same size. It does NEED a decent flat plate bolted to the wire shelf for the press to bolt to.
Remember I was concerned about ability to get press into backyard where the anvil is setup with my work tables? Not a problem - little more hassle to roll press out than is the forge, but not a real problem. Here they are setup with forge heating up.
Here's an old truck axle I had laying around, it's about an inch diameter. This is one press with the drawing die. I think it would have pinched it into had I tried. While it won't do what a 25 ton press does, I think it's going to be ok for what I want.
Sorry, no videos yet - got to get some help to make videos. It takes both hands to run the press. So far I'm doing ok with the hand control rather than foot control. We'll see how it goes as time goes by.