hope this is in the right spot 
I have been wanting to build a forge for a very long time, so when John tells me that he has an old kiln that we might can sacrifice and build one..i was all over it! i would also like to point out that we are in no way experts, but we did do a lot of research before we started
So he shows up and this thing is huge! the inner dimentions are 24x24x24, our plan is to cut the volume in half. we will lay it on its side where the door opens down and fill the bottom half with kwool, and then line it with refractory. that should leave us a space that is 24 wide x 12 tall x 24 deep. the burners will come in at roughly a 45deg angle, mainly because we have holes there already also because we want the heat to swirl inside the box.
Big Thanks to Matt Paul of MP Knives for letting me bounce ideas off him and answering all my stupid questions
ok Picture time!
The guys at work trying to figure out what we are doing the one with the open lid is going to be the forge...the one in the back is our new bigger HT oven..
getting all the parts together for the burners..
Building the gas nozzle. Thats a .030 mig tip and a swedge lock plug that we
building the flair....dont laugh it worked
I have been wanting to build a forge for a very long time, so when John tells me that he has an old kiln that we might can sacrifice and build one..i was all over it! i would also like to point out that we are in no way experts, but we did do a lot of research before we started
So he shows up and this thing is huge! the inner dimentions are 24x24x24, our plan is to cut the volume in half. we will lay it on its side where the door opens down and fill the bottom half with kwool, and then line it with refractory. that should leave us a space that is 24 wide x 12 tall x 24 deep. the burners will come in at roughly a 45deg angle, mainly because we have holes there already
also because we want the heat to swirl inside the box.Big Thanks to Matt Paul of MP Knives for letting me bounce ideas off him and answering all my stupid questions
ok Picture time!
The guys at work trying to figure out what we are doing
the one with the open lid is going to be the forge...the one in the back is our new bigger HT oven..getting all the parts together for the burners..
Building the gas nozzle. Thats a .030 mig tip and a swedge lock plug that we
building the flair....dont laugh it worked
