Kabar

R Appleby

KNIFE MAKER
Hello All, Nothin fancy but glad to get another project off the list. A long while back a workmate lost his issued Kabar and asked me to make him a new one. So here it is.

Blade; 7 inch, Bead blasted, Saber ground with fuller, CPM S35VN

Guard; 440C

Handle; Bead Blasted Black G10

Pommel; CPM S35VN

OAL; 12 inches

Sheath; Boltron


Thanks for looking
 

wdtorque

Well-Known Member
Thanks Dozier, I'm Getting closer to your project. Hope ya managed to stay out of the water.

No worries Robert. Good things take time. :)
I was fortunate at my house, my co-workers not so much. Two took on water. It was a heck of a flood, drainage's could not handle it all.
20-30" of rain in a two day period is just too much. I had a friend stuck in his car on I-12 East of Baton Rouge for 30 hours, but his house didn't flood. Crazy.
 

R Appleby

KNIFE MAKER
No worries Robert. Good things take time. :)
I was fortunate at my house, my co-workers not so much. Two took on water. It was a heck of a flood, drainage's could not handle it all.
20-30" of rain in a two day period is just too much. I had a friend stuck in his car on I-12 East of Baton Rouge for 30 hours, but his house didn't flood. Crazy.

Glad to hear you made it through OK, I used to live in the flood zone. Flooded 7 times in 17 years. I was finally able to get out f there now I live atop a mountain and my feet stay dry.


Thanks all for you kind remarks.
 
Top