J.Leclair
Well-Known Member
Finally things have gotten back to normal after the craziness of the holidays. I finally started my first and second of 2016. Just a couple little guys in Alabama damascus.
I found these two off cuts that I've had laying around the shop for well over a year. To tell the truth after I cut the knife blanks from the bars the off cuts got tucked away in my junk drawer and forgotten until this morning while searching for matches to light the heater. Decided to make up a couple paring/edc/necker type knives.
Got them profiled and bevels ground up to 220
then started hand sanding on one before calling it an evening
The longer one is 6 7/8" long with a 3 1/8" blade the smaller one is 6 1/8" long with a 2 7/8" blade
I found these two off cuts that I've had laying around the shop for well over a year. To tell the truth after I cut the knife blanks from the bars the off cuts got tucked away in my junk drawer and forgotten until this morning while searching for matches to light the heater. Decided to make up a couple paring/edc/necker type knives.
Got them profiled and bevels ground up to 220
then started hand sanding on one before calling it an evening
The longer one is 6 7/8" long with a 3 1/8" blade the smaller one is 6 1/8" long with a 2 7/8" blade