My new frame lock
- Thread starter JTClark
- Start date
T
TKC
Guest
I would like to see the lock side,and the lock engagement.I like what I see. I personally do not care for thumb disks.
JTClark
Well-Known Member
TKC,
I did not photo the lock up, when I have in the pasted I hardly ever post them unless its going to a customer. The engagement looks alittle deep from that angle, but its is about 1/2 to 2/3 the lock face on the bar.
I still do thumb studs and oblong holes, but I like discs, they're ambi and I think, clean looking. Don't read this as an arguement, I half had the idea of carring this one so I was angling it toward me, but we'll see.
I got the original design from Dave Clark (no relation) and this was enlonged about 1" from the orginal, then I tweaked that a bit.
Jason
I did not photo the lock up, when I have in the pasted I hardly ever post them unless its going to a customer. The engagement looks alittle deep from that angle, but its is about 1/2 to 2/3 the lock face on the bar.
I still do thumb studs and oblong holes, but I like discs, they're ambi and I think, clean looking. Don't read this as an arguement, I half had the idea of carring this one so I was angling it toward me, but we'll see.
I got the original design from Dave Clark (no relation) and this was enlonged about 1" from the orginal, then I tweaked that a bit.
Jason
Last edited:
Frank Niro
KNIFE MAKER
Yes, very slick and neat looking !!! Frank
T
TKC
Guest
Jason, I understand. Thank you!!
Chuck Gedraitis Knives
Well-Known Member
I like it. I think that it is nice and sleek, thin and clean looking perfect for EDC. It's a well thought out design. The only thing I would change is to not put the cutout in the handle, it breaks up the lines of the knife.
