Recurve Tactical @@@SOLD@@@
SOLD
Made this one from 52100 ball bearing steel. Sweet curves along with a sharpened clip make this one bad to the bone. Here are the specs:
Steel- 52100 X 3/16 approximately
AOL- 12 inches
Grind- Flat double ground
HT- In house, double quenched with 3 two hour temper cycles
Blade- 7 inch hair popping edge with 4 3/4 inch sharpened clip.
Finish- Hand sanded to 2000 grit
Handle- Approximately 5 inches
Scales- Green G10
Hardware- 416 stainless tube and stainless Loveless bolt
Sheath- .80 Concealex set up for YOUR large Tek-Lok. Vertical or Horizontal carry, left or right handed.
Asking 200.00 shipped in the USA
Paypal, USPS M/O, or Certified check preferred. Email for other options
Questions or comments welcomed
Thanks for looking
SOLD
Made this one from 52100 ball bearing steel. Sweet curves along with a sharpened clip make this one bad to the bone. Here are the specs:
Steel- 52100 X 3/16 approximately
AOL- 12 inches
Grind- Flat double ground
HT- In house, double quenched with 3 two hour temper cycles
Blade- 7 inch hair popping edge with 4 3/4 inch sharpened clip.
Finish- Hand sanded to 2000 grit
Handle- Approximately 5 inches
Scales- Green G10
Hardware- 416 stainless tube and stainless Loveless bolt
Sheath- .80 Concealex set up for YOUR large Tek-Lok. Vertical or Horizontal carry, left or right handed.
Asking 200.00 shipped in the USA
Paypal, USPS M/O, or Certified check preferred. Email for other options
Questions or comments welcomed
Thanks for looking
Last edited:
