cardoso5fr
Well-Known Member
A very bad week. Wednesday when i was putting the tang pin in the blade... The hammer hitted the edge (115w8 oil hardened and flash tempered to the gold...). Hardened steel between hammer and anvil is not a good idea. A piece of blade flight .... I though to discard the blade. ....
Thursday, a lot of personnal worry... (nothing really important but that is never cool).
Friday.... I want to turn on my grinder... The speed variator did a "CLAC". And smell burned plastic.... It's dead..... I have no grinder...
I'm happy. As i wasn't able to work on another blade... I did handle for that scrap...
I save the blade as i could. I did g10 handle.... That flip well. but it's really iight
14 cm closed. 24,1 cm open, sharp 10 cm.
Poor flip session, there was a lot of wind and that was a bit difficult to catch the bali
[youtube]http://www.youtube.com/watch?v=G6SkJO71ONo[/youtube]
Thursday, a lot of personnal worry... (nothing really important but that is never cool).
Friday.... I want to turn on my grinder... The speed variator did a "CLAC". And smell burned plastic.... It's dead..... I have no grinder...
I'm happy. As i wasn't able to work on another blade... I did handle for that scrap...
I save the blade as i could. I did g10 handle.... That flip well. but it's really iight
14 cm closed. 24,1 cm open, sharp 10 cm.
Poor flip session, there was a lot of wind and that was a bit difficult to catch the bali
[youtube]http://www.youtube.com/watch?v=G6SkJO71ONo[/youtube]