Recent content by mwhuston

I made mine from plans by Chris Crawford https://chriscrawfordknives.com/home/# Dan Comeau has a plan too. http://dcknives.blogspot.com/p/poor-mans-etching-power-supply.html

Hi Bob. Where in Montana aremyiu located? I'm in Missoula. There are multiple knife Maker's across the state.

Good luck tomorrow

Most hosting sites allow WordPress. It's pretty easy since you can use templates and do modifications. It also allow for custom plugins. There are many free plugins that allow a lot of features.

Praying for you and your family.

I used the NWG plans with a step pulley too. I just keep it in the slowest speed for simplicity

I have found that the 5 gallon bucket paint stirs from home depot work pretty well. I have a small block similar to this, not sure if it's the same manufacturer that I picked up at an automotive paint store. I like it a lot, but it's about 3x6 size. I cut it in half and use it that way. I use...

The MKA show is 11-12 August in Missoula, Montana. There are a few tables open if anyone is interested.

Has anyone tried to use a stencil made on a sillouette machine? I was thinking of trying it for one time etching. My Maker's Mark I get from Ernie. There is a sticker stencil material for the machines that may work as a one time stencil.

440c steel and stabilized burl. I used 416 steel for the pins.

Need to come up with a design that will fit in a flat rate USPS box.

Good Idea

I like the profile