I've been buying steel when it presents itself at decent prices for years. For as few knives as I currently make, I have enough in backstock to not be very worried.
It will be interesting to see if the "scavenged" steel blades for sale increases over the near term.
Starting to get warm enough in the NW to spend some time out in the shop.
Finishing up a deer knife for my brother...just needs an edge. Finish isn't too precious...gonna get used hard.
I pulled this from a post made here on knifedogs.
My name is Bo Grospitch. I am Ernie Grospitch’s Son. I have taken over the Blue Lightning Stencil operation, and I am available to help with your stencil needs.
Please feel free to contact me:
720-379-4651 M-F (8:30a - 6:30p MST)
CONTACT VIA...
Maybe consider flared tubing instead of pins next go 'round? I'd be messing up that texture trying to work that pin down, and then have to grind the whole darn thing flat!
No worries.
My experience with Starrett O1 is stock removal and heat treat with a temp controlled oven and Parks quenchant. My results so far have been quite good for what many consider a so-so steel these days. Smacking with a hammer/uncontrolled heat treat in a forge as a newb is an invitation...
AO???
Never heard of it. Couldn't find any on-line. Do you have a pic of the raw product? Packaging?
I have Starrett O1 in small sheet form and it makes great knives...for an outdated, non-boutique, vintage product.
During WWII, Cattaraugus made a folding pilot's survival knife/machete, but I cannot recall seeing a folding full-size Bowie like I think you're describing.