I've had lots of problems with AEBL twisting and warping
This is what I do and it helpes a lot
I plate quench with plates in a vice and blast with compressed air
After a few minutes I take it out of the plates and out of the foil. Then I clamp it to a piece of angle iron. It's still quite...
As the title says, TAP controller for sale
The touch screen is not very sensitive. It often takes 2 or 3 touches for it to register. I talked to SDS Industries about this and they indicated that this is a known issue with this generation. That said, it works fine.
I should note that this came...
You can try a gravity feed gun.
It makes a mess and you'll lose at least some of your media depending on how use it but it works and is cheap.
I like the look I get with glass beads.
https://www.harborfreight.com/gravity-feed-blaster-gun-93221.html
I have always used blue loctite on my pivots after a thorough "run-in" as you described.
But I'm intrigued by the O-ring idea. I might give them a try. Thanks for the idea.
BTW I'd suggest to anyone reading this to never use red loctite. You or your customer will not be able to adjust or...
When I put my shop together I carefully picked out each piece of equipment
But for lighting I picked up the first stuff I saw on the shelf at Home Depot. Big mistake.
Lightning is one of the most important things in a knife makers shop IMO
I'll definitely try these out since I've been on the...
I've had over a dozen packages come and go since this whole corona thing happened and 1 was delivered on time
Mostly with USPS but UPS and FedEx too
I had 20 silver America Eagles disappear into the USPS abyss for 2 weeks. Thankfully they eventually showed up
Heck I've got one coming from...
You turn it over and the stopper lets go
What a mess
Got all over my brand new Mitutoyo calipers
Turns out acetone will damage the plastic on the calipers UGH!!
On the plus side, I remembered some 4 letter words that I haven't used in a long time
I think the tip and shape are perfect. It's a well balanced shape.
It's been my experience that changing things midstream doesn't always make stuff better.
I break all my edges with a Scotchbrite wheel
It gives a nice and smooth radius
Although I usually have to go back and sand the edges to get the scratches evened up and looking how I want