Search results

Tracy, thank you for your response. All the coils work and look the same. Here was my test. I ramped the oven to 400 and held for 30 min, the blade was 250 or so after that time. I then ramped to 600 and held for 30 min the blade was 450 or so. I then ramped to 950 and held for 30 min the...

Hi all, I resently purchased an Evenheat KF22.5 with a Ramp master control. I have had a couple if bad goes heat treating O1 and 4140. The just didn't get hard. I have done some tests with an infrared temp gage, and discovered the botom of my oven is about 200 degrees lower than the top...

Very good system. Ben Dahle ( the inventor) is also very easy to talk to.

If you make it just like Rob's you won't be sorry. His works great.

Use an abrasive stone (Aluminum oxide) in your Dremel.

I had good luck with Admiral Steel. Fast, good price, and any size you want.

Benchmade Griptillian... all day everyday! I have carried it everyday since Christmas 2009. My favorite pocket knife to date.

One other thing. I would expect to need to flip the knife blank at least once and maybe a couple times to get it truely flat. The is due to surface irregularities, internal stresses on the blank, and the dymnamics of how a mag chuck works.

Are you using a magnetic chuck? If your work piece is thin and not flat, it will suck down to the chuck, you grind it "flat" then when you turn the magnet off, it twists back to its original twist. You can remedy this be not using the magnet on the first side. Double stickey tape or a vise...

You can get a VFD that will "overdrive" your motor. I wouldn't do it, however, exceeding a motors rated speed will just wear it out faster.

I love EdgePro as well. You can rough in the edge on the grinder and finish it on the EdgePro. They are also awesome people to deal with.

It will work, However if you do pop the breaker a bunch it will get weaker in my experience. D

Nice machine. What are the surface feet per min of the speeds?

I really appreciate all you folks taking the time to share your views. I have a lot of reaserch to do! D

I have one as well and love it. Check out www.use-enco.com, www.mscdirect.com, or www.travers.com They all have them. Good luck, Duncan

Thank you Bill and David. I have been using Norton A/O shop roll 1" wide strips, but they aren't very flexable.

I'm excited for you! Have fun!

What is the best sand paper you have used for hand sanding annealled and hardened steel? I need to buy some quality sandpaper and would appreciate it if you would share you experience. Thanks, Duncan

I really like to composition of this knife.

Thanks for saving me a lot of headache!! I suppose I just have to make some belts or something!