1075/15n20 Damascus, 304SS, and Bog Oak Hunter

[Frank Hunter]

Here's another one that's just about finished up. This is my large hunter pattern with a 5.5" cutting edge 1075/15n20 5/32" thick damascus blade from Two Finger Knife (Admiral Steel supplied), 304 stainless fittings, and gorgeous Ukrainian bog oak from burlsource.us stabilized by WSSI. I'm working on this one's horizontal sheath along with the one for the previously shown knife as I figure this caliber of materials deserve some tooling. Fittings are mirror polished and this will be a real looker after I sharpen it.

 

[Wade Hougham]

Frank,
This one will look very nice, in someones hand, performing the job it was meant to do.
Wade

 

[Frank Hunter]

Here's some finished photos. I'll be adding a little more wax to the sheath as the stitching shows the burr holes more than I'd like but aside from that it's ready to go out the door.