3 Finger Skinner

[maxcutter03]

Here is a little 3 finger that I made for a customer in Florida. If you looked at the tutorial forum, its the same knife.

OAL 6.25"
Hollow grind
Blade CPM 154 CM
Scales Arizona desert ironwood burl
Bolsters 416 SS
Bolts Corby 316
Tapered tang

Your comments are all welcome!!!

All comments welcome....

 

[Jim Coffee]

thats a great looking knife, the fit and finish look top notch and i really like the bolsters..

 

[Leatherface]

great looking knife

 

[LR Adkins]

That is a really nice knife Marvin. Everything looks right on, excellent.

Larry

 

[shultram]

Hey boys got a noob question for ya. Why is it called a "3 finger" skinner? cheers in advance.

 

[Garry Odgers]

Great looking knife and sheath with excellent fit & finish on both. Enjoyed your tutorial too. I hope you post some more of your next knives.

 

[James Terrio]

Hey boys got a noob question for ya. Why is it called a "3 finger" skinner? cheers in advance.

Because it's short. A person with an average or large hand will only get three fingers wrapped around the handle, and their pinky will wrap around the butt. Little knives like that are very handy in tight spaces and this is a really fine example. 2thumbs

 

[maxcutter03]

Thanks fellas......

 

[ArtinNC]

Very nice, excellent fit & finish.

 

[mosto]

Really nice job. Congrats!

 

[mitch13]

Nice & clean my friend2thumbs
mitch

 

[calharkins]

Good looking knife Marv!! You done good!