SYD32
Well-Known Member
Here is knife #4.
The blade was hollow ground form 1/8th inch ATS-34. The blade is 4 inches long and 1 1/2 inches wide(deep). The handle is 4 inches long. The bolsters are nickel silver. The handle material is desert ironwood that dovetails into the bolsters. I did the file work from the handle up along the blade. I used a stainless steel liner in the handles because i thought it would make the file work a little more interesting. Mosaic pins hold it all together.
Any comments good or bad are welcome.
Thanks!
The blade was hollow ground form 1/8th inch ATS-34. The blade is 4 inches long and 1 1/2 inches wide(deep). The handle is 4 inches long. The bolsters are nickel silver. The handle material is desert ironwood that dovetails into the bolsters. I did the file work from the handle up along the blade. I used a stainless steel liner in the handles because i thought it would make the file work a little more interesting. Mosaic pins hold it all together.
Any comments good or bad are welcome.
Thanks!
