Bird and Trout

taylormadeknives

taylormadeknives

Well-Known Member
Bird and trout knife
AEB-L steel
Hollow ground
Stabilized Ramon burl
Red G-10 liners
Copper pins
Copper mosaic pin

I finished this one up today. It will be a retirement gift. What do you guys think?

ube5asav.jpg


4esa9yta.jpg


devemu5u.jpg


nudypepe.jpg


Sent from my SPH-L710 using Tapatalk
 
I like it.
My only concern would be how it feels on the pinky with that swell all the way to the rear of the handle? If the pinky is stressed it can make your hand tired.
 
rhinoknives said:
I like it.
My only concern would be how it feels on the pinky with that swell all the way to the rear of the handle? If the pinky is stressed it can make your hand tired.
Click to expand...

I hear what your saying. It is about a 3 finger grip. Your pinky lays on the angled area at the heel. It feels comfy to me, but I will keep that in mind. Thank you!

Sent from my SPH-L710 using Tapatalk
 
Thank you! Close. It is Swedish, but not Elmax variation. It is a Bohler steel that is basically the same as Sandvik 13C26. It has 13% Chromium for a real high corrosion resistance. I think it was a good choice for a bird and trout knife that will see quite a bit of water

Sent from my SPH-L710 using Tapatalk
 
You must log in or register to reply here.
Back
Top