CPM 10V Heat Treating Options

L

Lance Carrico

Member
I've played with CPM 10V only a little but really like it for smaller knives. I heat treated to Crucible specs at 2,150, plate quenched, then tempered at 1,020 for 2 hours X 3. My question is...seems lots of folks are liking to cryo CPM 3V , then temper it at 400. Is it the concensus to do the same with CPM 10V in regards to adding the cryo and doing the low temp tempers?

Has anyone done this? And, what were your results?

Thanks,
Lance
 
You must log in or register to reply here.
Back
Top