Damascus drop point

J.Leclair

J.Leclair

Well-Known Member
Just finished up this little drop point hunter in 1084/15N20 damascus. With wssi stabilized double dyed (orange/black) box elder burl. 3.25" BL and 7.5" OAL Nickle silver pin and tube. Since today is my birthday I think I might keep this one, unless I decide to sell it lol
DSCN1197.jpg

DSCN1200.jpg

What do you all think?
 
Well Happy Birthday to you!
Nice little hunter. I would suggest that you find a bit more curve in the handle, And or,

relieve the area for the index finger and drop the blade a bit more.
The knife will fit the hand a bit better and some curves look good, and always help sell knives!

Laurence

www.rhinoknives.com
 
rhinoknives said:
Well Happy Birthday to you!
Nice little hunter. I would suggest that you find a bit more curve in the handle, And or,

relieve the area for the index finger and drop the blade a bit more.
The knife will fit the hand a bit better and some curves look good, and always help sell knives!

Laurence

www.rhinoknives.com
Click to expand...

I agree with Laurence,And Happy Birthday,also a small fit and finish thing that will help the look is take an 82* countersink and countersink the ends of the thong hole tube,will make it look flared and add to the knife.
Good looking knife sir.

Stan
 
this bar of damascus was just barely over 1" wide so didnt have much wiggle room to begin with. I agree it would look better with more drop to the butt and more of a finger relief. I appreciate the constructive critisism, and thanks for the b-day wishes :)
 
You must log in or register to reply here.
Back
Top