Daniel's Knife

J

Joel

Well-Known Member
A Canadian friend asked me to modify one of my basic designs, which I did. Liked it much better than my original, so I put his name to it. Blade is flat ground CPM154CM in 3/32" diameter and it's 4.5" from tip to plunge. It's 9" OAL and 5 oz. Wood is Stabilized Koa and the the trim is copper.
Picture391.jpg

Picture390.jpg

Picture392.jpg
 
I like it. I am planning to do a hunter w/ curly maple. I think you did a wonderful job!

Eric
 
Very nice work. I see a growing use with copper... I like it with the wood you chose. I think a custom feature that would set this knife apart would be a tapered tang... just a thought.
 
You must log in or register to reply here.
Back
Top