Is this a specific pattern per se or terminology used to describe just about any slip joint without front bolsters? I'm new to the whole slip joint thing, so I'm trying to get an understanding of the various patterns, terminology, etc.
Another question regarding the lack of front bolsters is the use of washers. Is this done to improve the look (i.e. the pivot pin might otherwise look too small) or to reinforce the handle material for pinning? If done for reinforcement, is it only necessary with natural scale materials and safe to omit if using phenolics?
My first slip joint does't have bolsters and I wasn't planning to use washers; however, now I'm questioning whether or not that is a wise decision. For reference, handle material is Ivory linen Micarta.
Another question regarding the lack of front bolsters is the use of washers. Is this done to improve the look (i.e. the pivot pin might otherwise look too small) or to reinforce the handle material for pinning? If done for reinforcement, is it only necessary with natural scale materials and safe to omit if using phenolics?
My first slip joint does't have bolsters and I wasn't planning to use washers; however, now I'm questioning whether or not that is a wise decision. For reference, handle material is Ivory linen Micarta.