OkieCowboy
Well-Known Member
... in between a couple of other projects... I had a couple of scrap pieces of steel ..1095..one of them had a blade inside just dieing to be let out... so somehow I am on my way to building my first friction folder...I want a more modern design. .. (keep.in mind..I am kinda winging this..building as I go) so...what size pivot does o e normally need to start with? I was thinking maybe 3/16...am I way off base here? And length wise...do you cut to length? What about any standoff or anything? Same deal???
Also any concerns when sending these smaller folder blades off for heat treating?
Thanks so much for the advice..!!!
Also any concerns when sending these smaller folder blades off for heat treating?
Thanks so much for the advice..!!!