C Craft
Well-Known Member
So here is the question when using, G/Flex 650 Toughened Epoxy have you ever thinned it??
If so what did you use to thin??
I got into a situation today where there was no way to apply epoxy to the area, except by injecting it in there. I took a Cajun injector syringe needle and cut the needle at an angle, where it already has an opening! I thinned my epoxy with acetone enough to be able to draw it into the syringe. Shot it in where the epoxy was needed and now I wait!
Wait to see if acetone was the right thing to thin and if it will harden after thinning. I have done this with other two part epoxies but, never G/Flex 650!!
Anyone got experience with thinning G/flex 650 with acetone??? And if so how did it turn out???
If so what did you use to thin??
I got into a situation today where there was no way to apply epoxy to the area, except by injecting it in there. I took a Cajun injector syringe needle and cut the needle at an angle, where it already has an opening! I thinned my epoxy with acetone enough to be able to draw it into the syringe. Shot it in where the epoxy was needed and now I wait!
Wait to see if acetone was the right thing to thin and if it will harden after thinning. I have done this with other two part epoxies but, never G/Flex 650!!
Anyone got experience with thinning G/flex 650 with acetone??? And if so how did it turn out???