Need some help with a Robert Appleby Knife

L

lrsu

New Member
I am in need of some help. I have a Robert Appleby Survival knife Specs below. That I am trying to find an estimated value for.

Specs are;

Blade ; Differentially tempered 5160, 5" X 1/4" thick X 1 1/4" wide, flat ground to spine with a convexed edge. Blade has 2 3/4" x 1/4" fuller and unsharpened
clip point.

Handle; Inclined knurled thumb ramp, Index finger recess for better retention and blade control. 4, 1/4" chamfered holes for lashing to a pole for use as a spear
[FONT=verdana, arial, sans-serif]or extended weapon. Extended tab on but for prying and glass breaker. Handle scales are fluted bead blasted black G10 attached with Chicago screws. **Note:
Mine looks to have canvas Micarta.[/FONT]
Robert Appleby.JPG
OAL; 10 1/4"



Thanks for any help!
 
I do not recall what Bob was selling them for , But not a one of a kind I believe he did a run of them. Did you try contacting him? Great guy to work with and an even better craftsman
 
You must log in or register to reply here.
Back
Top