springer82
Well-Known Member
I've had two damascus blades sitting around for awhile. Both thin chief blades. One I forged down to far and it did not clean up. The other went "ping" when it went in for the quench.
I took my cutoff grinder and cut them into small pieces. I also cut up some 15n20. I'm going to give canister damascus a shot. I have some 1095 power for a filler. Tomorrow after work I'll put it all together and see what happens. No press. Bummer!! I'll start with a hammer and move to the 25lb LG. Time will tell.
I took my cutoff grinder and cut them into small pieces. I also cut up some 15n20. I'm going to give canister damascus a shot. I have some 1095 power for a filler. Tomorrow after work I'll put it all together and see what happens. No press. Bummer!! I'll start with a hammer and move to the 25lb LG. Time will tell.