Dan Seaver
KNIFE MAKER
Hey guys.
I finally got my heat treat oven ready but when I went to fire it up I ended up with a display that says EEEE.
The instructions can be found here: http://www.temperaturecontrolwiki.c...oak-64-Profile-Segments-Arizona-Phoenix_4.pdf
I have it programed for a type K thermocouple so that isn't the issue.
I think its problem B) "Input signal value is beyond the high or low limit. " Does anybody know what the input signal value should be and how to adjust it?
Thanks!
-Dan
I finally got my heat treat oven ready but when I went to fire it up I ended up with a display that says EEEE.
The instructions can be found here: http://www.temperaturecontrolwiki.c...oak-64-Profile-Segments-Arizona-Phoenix_4.pdf
I have it programed for a type K thermocouple so that isn't the issue.
I think its problem B) "Input signal value is beyond the high or low limit. " Does anybody know what the input signal value should be and how to adjust it?
Thanks!
-Dan