Ausbrooks
KNIFE MAKER
Recently finished this bird trout liner lock - wanted to see if could split a stag taper and put on a folder and pulled it off but had to grind off the popcorn to thin it down which was traumatic. The narrow design challenged me on the stop pin/lock geometry and had to remake lock side but learned a lesson so guess worth it. This one will stay home as had other problems (stencil tool arc'd out on right side and boogered lettering, more trauma) but all in all don't look too bad and should gut a pheasant or two.
Specs: .125 X 4" CPMS60V RC60 blade, forged/hardened 1084/15N20 bolsters, hardened and fileworked damascus backspacer, Ti frame, sambar stag scales, bronze washers, 1/4" pivot, and SS lanyard pin and paracord lanyard.
Thanks for lookin' and appreciate all input.
Specs: .125 X 4" CPMS60V RC60 blade, forged/hardened 1084/15N20 bolsters, hardened and fileworked damascus backspacer, Ti frame, sambar stag scales, bronze washers, 1/4" pivot, and SS lanyard pin and paracord lanyard.
Thanks for lookin' and appreciate all input.
