Few pics of a framelock flipper I just finished along with some info. Thanks to Tracy for a good supply of materials available to use. When I need supplies USA Knife Makers is the first place I look.
Steel- cpm3v x 3/16
HT- In house to 59-60rc
Open length- 9 3/8 inches
Closed- almost 5 1/2 inches
Blade- 3 3/4 inches
Grind- Flat with swedge and jimping
Finish- Stone Washed
Frame
Lockside is .160 bead blasted and anodized titanium
Off Side is .70 bead blasted and anodized titanium with Carbon Fiber scale
Detent- 1/8 stainless
Pivot- 3/16 stainless chain bolt with bronze washers
Back spacer black G10
Titanium pocket clip for right hand tip up carry
Stainless hardware and stop pin
Steel- cpm3v x 3/16
HT- In house to 59-60rc
Open length- 9 3/8 inches
Closed- almost 5 1/2 inches
Blade- 3 3/4 inches
Grind- Flat with swedge and jimping
Finish- Stone Washed
Frame
Lockside is .160 bead blasted and anodized titanium
Off Side is .70 bead blasted and anodized titanium with Carbon Fiber scale
Detent- 1/8 stainless
Pivot- 3/16 stainless chain bolt with bronze washers
Back spacer black G10
Titanium pocket clip for right hand tip up carry
Stainless hardware and stop pin
