RickA
Well-Known Member
Hi everyone
While fetching some steel for my KMG grinder build last week, I saw a bunch of broken power hacksaw blades at the steel supplier. He said I was welcome to take them, so I did.
I have seen quite a few guys have used circular saw blades to make knives, i think that the steel in the power hacksaw blades should be good for some small blades, any ideas? Is it worth it?
These blades appear to be a single piece of steel rather than a hard edge bonded to a spring steel back.
Thanks
Rick
While fetching some steel for my KMG grinder build last week, I saw a bunch of broken power hacksaw blades at the steel supplier. He said I was welcome to take them, so I did.
I have seen quite a few guys have used circular saw blades to make knives, i think that the steel in the power hacksaw blades should be good for some small blades, any ideas? Is it worth it?
These blades appear to be a single piece of steel rather than a hard edge bonded to a spring steel back.
Thanks
Rick