Hi all,
I am just waiting on delivery of my NWG parts and I am starting to plan out my build.
I have a Baldor 1.5hp single phase motor and I am planning out the wiring.
I got thinking it would be nice to be able to run the grinder for edge up grinding so belt running towards the floor. Then running belt up towards the ceiling for polish and convex edge with cork/scotchbrite belts so also edge up.
My motor can be wired for either direction.
My question is can I wire in some kind of 3 position switch that can run forward, reverse, and off?
Can this be done?
Thanks.
I am just waiting on delivery of my NWG parts and I am starting to plan out my build.
I have a Baldor 1.5hp single phase motor and I am planning out the wiring.
I got thinking it would be nice to be able to run the grinder for edge up grinding so belt running towards the floor. Then running belt up towards the ceiling for polish and convex edge with cork/scotchbrite belts so also edge up.
My motor can be wired for either direction.
My question is can I wire in some kind of 3 position switch that can run forward, reverse, and off?
Can this be done?
Thanks.