SYD32
Well-Known Member
I know this topic has been addressed before but I can't find it in my searches. When I etch my maker's mark on a knife I use a stencil from Ernie and a personalizer plus. I always use blue painters tape to keep my stencil flat an the blade. I use the felt pads that came with the machine as well as the solution. So the problem is that I get a line etched into the blade along the edge of the stencil. The line is verbally as deep as the maker's mark. Since etching is usually the last step I do it is always a pain to go back and remove this line.
Thanks for any assistance you can provide.
Thanks for any assistance you can provide.