C Craft
Well-Known Member
I want to attempt a Moran style handle, similar to this one!
I found a block of Ironwood that is 6.85 X 3.36 X 1.52
So the length at 6.85, sounds good, the width at 3.36 should be enough to get the kick down in the rear of the handle and 1.52 on thickness should be good as well!
So the question is this.
How big a block of wood does it take to get this style of handle out of???
Could I go with less??? The larger the piece the larger the money!!
I found a block of Ironwood that is 6.85 X 3.36 X 1.52
So the length at 6.85, sounds good, the width at 3.36 should be enough to get the kick down in the rear of the handle and 1.52 on thickness should be good as well!
So the question is this.
How big a block of wood does it take to get this style of handle out of???
Could I go with less??? The larger the piece the larger the money!!