Johnny Roberts
Well-Known Member
I posted a question over in the Beaumont Metal Works forum about my KMG. Rob responded very quickly but we are both scratching our heads a bit.
I was running my KMG with a step-pulley setup. I upgraded to a variable speed controller.
I can turn it on but as soon as I engage the START switch, it throws the Ground Fault Interupter Circuit.
The manual plainly states not to use these on outlets with GFI. I was hoping for the best but it is definitely not working.
I can plug the grinder into other parts of the house that do not have GFI protection and it works just fine.
Has anyone else run into this problem and successfully worked out a solution?
Many thanks,
Johnny
I was running my KMG with a step-pulley setup. I upgraded to a variable speed controller.
I can turn it on but as soon as I engage the START switch, it throws the Ground Fault Interupter Circuit.
The manual plainly states not to use these on outlets with GFI. I was hoping for the best but it is definitely not working.
I can plug the grinder into other parts of the house that do not have GFI protection and it works just fine.
Has anyone else run into this problem and successfully worked out a solution?
Many thanks,
Johnny