Mark Andrews
Well-Known Member
I have been forging in my taper in my knives front to back. when I get to the rough out stage I often make the mistake of taking to much off one side. So at this point I end up chasing a perfect taper and often times I fall short and I end up pretty frustrated .
If I go with a center line down the spine would that show up as even on a pre tapered blade. Or would I be better off scraping the forged in taper clean the blade up do a center line on a flat blade and then do the taper.
Thanks for any tips.
If I go with a center line down the spine would that show up as even on a pre tapered blade. Or would I be better off scraping the forged in taper clean the blade up do a center line on a flat blade and then do the taper.
Thanks for any tips.