BrianBoyles
Well-Known Member
Hello
I am stumped on this one,
I just got a telemecanique altiver 11 vfd
It powers up. The fan runs and the screen reads ready. But I am not getting power to the motor.
my motor is a 3 phase 1hp baldor.
I wired everything as follows
wires t1 t7 to u on the drive
wirest5 t2 to v on the drive
wires t3 to t9 w on the drive
t4 t5 t6 are wired together
I am trying to figure if i am missing something or if the drive is bad.
I am stumped on this one,
I just got a telemecanique altiver 11 vfd
It powers up. The fan runs and the screen reads ready. But I am not getting power to the motor.
my motor is a 3 phase 1hp baldor.
I wired everything as follows
wires t1 t7 to u on the drive
wirest5 t2 to v on the drive
wires t3 to t9 w on the drive
t4 t5 t6 are wired together
I am trying to figure if i am missing something or if the drive is bad.