SYD32
Well-Known Member
I recently purchased 6 feet of 5/32 x 1 1/2 CPM 154 CM. The steel is very rough on the surface, lots of pits and dimples. I've been cutting out the profile of the knife then trying to true it up on 9" disk sander or on the flat platen of my TW-90. I am not getting very good results with this. A: it is very time intensive. B. I burning through a lot of belts and disks. I guess I should order my steel precision ground next time. Any other suggestions or tricks to cleaning up the flats of the blades?
Thanks
Sabri
Thanks
Sabri