Hi. My name is Shawn Fowler. I've been making knives (If you can call it that) since I was in Junior High, but have only recently gotten to where I think they are half way decent. It's a part time thing for me know, but I would like to make a living at it some day. I have a web page that is in it's very early stages and a Facebook page. I am exited to get good advice from the experience knife makers out there and am looking forward to any helpful advice. One problem I am having right now that has me perplexed is that when I drill holes they are tapered wider at the top than at the bottom. I am suspicious that this may be due to low quality drill bits. I wasn't having the problem in the past. Any advice would be greatly appreciated. Thanks.
Last edited by a moderator: