Chris Martin
Well-Known Member
Hello all,
I have become inspired by watching all the WIP threads on the forums. Only been considering making knives for a year now. I think I am finally ready to give it a shot after reading/viewing every darn thread possible.
I dont have much for trade at the moment.
NIB Fossil watch w/camo dial:
http://www.fossil.com/webapp/wcs/st...-BD81-DE11-B7F3-0019B9C043EB&mr:referralID=NA
I also have a titanium sheet that measures .048x 3 1/2"x 36"
I know, its a long shot. But I am just wanting to start playing around, screwing up steel to get the hang of this!
I will take just about anything from 5160-D2-0-1.....whatever to get me started. 1/8-1/4" would be great.
If any of you guys/gals have some scrap just laying around and could use a decent watch just shoot me a PM.
Thanks in advance
45
ETA: Might be putting up a Busse FFBM or CGFBM once I decide I can let one go
I have become inspired by watching all the WIP threads on the forums. Only been considering making knives for a year now. I think I am finally ready to give it a shot after reading/viewing every darn thread possible.
I dont have much for trade at the moment.
NIB Fossil watch w/camo dial:
http://www.fossil.com/webapp/wcs/st...-BD81-DE11-B7F3-0019B9C043EB&mr:referralID=NA
I also have a titanium sheet that measures .048x 3 1/2"x 36"
I know, its a long shot. But I am just wanting to start playing around, screwing up steel to get the hang of this!
I will take just about anything from 5160-D2-0-1.....whatever to get me started. 1/8-1/4" would be great.
If any of you guys/gals have some scrap just laying around and could use a decent watch just shoot me a PM.
Thanks in advance
45
ETA: Might be putting up a Busse FFBM or CGFBM once I decide I can let one go
Last edited by a moderator: